VAX

    ZYPCOM 7/30/96

    VAX with terminal server setup with ZYPCOM Z34-SX/SE/RX, Z32t-SX/SE, Z32b-SX/SE modems
    From a dumb terminal set the following states:AT&F&C1&D2E0Q1S0=2&K4&W
    This sets the following conditions:
    All normal types of dial-in connections are supported.
    NO ECHO of characters.
    NO Result Codes
    XON/XOFF flow control.
    -change &K4 to &K0 for no flow control
    -change &K4 to &K3 and add &S1 for RTS/CTS flow control

    CARRIER DETECT follows carrier state.
    DTR followed from server (modem will not answer if DTR low and will disconnect if DTR dropped while carrier is present.)
    ANSWER on 2nd RING (change # S0 is equal to change)

    NOTE:
    !!!MODEM will talk to server at the serial port rate the terminal was
    at when the init. string was issued.!!!

    Terminal server utility setup:
    The system can be setup to detect a login attempt based on any of the following:
    RI pulse (Hardware RING line - pin 22)
    DCD high (Data Carrier Detect active - pin 8)
    RD activity (Characters being sent on RD line - pin 3)
    The system can force a disconnect by dropping DTR - pin 20)
    The system can detect a disconnect by loss of DCD - pin 8)
    The system can be set to either AUTOBAUD or forced to the rate the dumb terminal
    was set to when the modem was programmed.
    In either case, the modem serial port rate will match the rate used when programmed.

    ZYPCOM 7/30/96

COMPANY INFO | WHATS NEW | SALES INFO | PRODUCT INFO | SERVICE & SUPPORT
DISTRIBUTORS ONLY | WARRANTY REGISTRATION | GUEST BOOK | HOME

ZYPCOM, Inc
29400 Kohoutek Way, Suite 170
Union City, CA 94587-1212
Tel: 510-324-2501 Fax: 510-324-2414